Top Tips For Birmingham Water Heater Maintenance

Maintenance Tip #1 Preparing the Birmingham water heater

• Turn off the power if its a Birmingham electric water heater.
• Turn off the water to the water heater by closing the valve on the cold water line. Its located on top of the water heater. The cold line is always to the right.
• Open a hot water tap inside the house. Air pressure will come out of the tap.
• Open the drain valve located at the bottom of the water heater. It looks like a hose bibb. Let a gallon or more out of the water heater.
• Do not allow anyone to use hot water for the time you are working on the water heater.

Maintenance Tip #2 Why do maintenance?

The information in this article isn’t public knowledge. It should be. It is also very difficult to find any maintenance information about water heaters anywhere.
These tips will make your Water Heater more heat efficient, and far less capable of causing problems down the road. Most maintenance is quick and cheap as well.

Maintenance Tip #3 When can a gas water heater receive maintenance?

Turn the control dial to PILOT. Look inside the combustion chamber once the flame is out with a flashlight. Do you see any water, rust, or water marks? If yes, then you’ll probably need to invest in a brand new water heater altogether. If no, then maintenance of the water heater will be an option for you.

Now look on top of the gas water heater at the chimney baffle. It’s the long piece of tin metal that extends to the ceiling usually. Does it have any rust on it? If yes, then you have poor ventilation in the room with the water heater in it. Call a Birmingham plumber for advice on your situation, because you don’t want a hole rusted through the tin metal. If no rust appears, maintenance can be performed.

Maintenance Tip #4 Recording the maintenance you do.

Put a large sticker on the outside of the water heater, but don’t put it on anything important. Record the date when you check or replace the anode rods. Also write down any time you flush the tank out. If any new parts are used, write the part and date down too.

Maintenance Tip #5 Anode inspection

Check your anode rods every two or three years. Every once in awhile the anode location is written on the instruction on the outside of the water heater.
You may have a combination anode rod. This means that it is attached to the hot water outlet on top of the water heater.

To find out if you have one, disconnect the plumbing at the water heater and the hot water outlet, which is always on the left. Poke a clothes hanger wire straight down inside the hole. If it hits something a few inches inside, you have a combination anode. Use a pipe wrench to remove the combination anode.

You may have an anode rod underneath a plastic disc only 2 inches wide or less. Pop the disc and then use a 1-1/16 inch socket wrench, a 3/4 drive, and a breaker bar. Any person may have to steady the tank when you unscrew the anode rod.

Follow these 5 tips to keep your Birmingham water heater maintained and up-to-date. If any of these steps seem out of your league, don’t worry. Just call your local Birmingham Water Heater Maintenance contractor and they’ll be able to take care of it for you. Either way, Birmingham Water Heater Maintenance is essential for the life of your water heater.

Article Source: https://EzineArticles.com/406998